Driver fatigue monitor with signal output 45km/h start-up speed
Description
When driving two hours at a speed of 100km/h, the driver has to struggle to stay awake on account of his lower levels physiological functions followed by inattention. In general, accidents rates are extremely high when the driver drives over 6 hours a day or is lack of proper rest (less than 4 or 5 hours ) According traffic accidents analysis from Europe and USA, 80-90% was caused by human factors. In USA, about 100,000 traffic accidents were caused because of fatigue or drowsy driving every year, which leads to 1500people die, Similar situation in Europe? take Germany as an example, 25% of traffic accidents were caused by fatigue or drowsy driving.
Power input and output
| Input |
9-36V |
| power consumption |
100mA in 12V car, and 60mA in 24V car |
| I/O output |
high resistance status under normal status, low voltage output when triggered |
| Working Temprature: |
0-80℃ |
| Working Humility: |
10%-90% |
| Weigh: |
108g |
| Demension: |
4.5*10.2cm |
I/O and RS232 output optional:
I/O output is only a high/low voltage output, you can get only the alarm signal,the connection is easy. The default setting is high resistance status under normal status, low voltage output when triggered.
RS232 output has alarm signal and picture output, thus you can get the driver's face picture in the center, it need to integrate to the GPS system via protocol.
Attention:
Non-authorized person, please do not open or repair the device.
Please do not operate the system when driving to avoid dangerous
Please handle carefully, do not drop or impact with hard objectives
Do not use chemicals or cleaning agents to clean the machine, it will damage the machine surfaces or rust the paint.
keep it away from water or moist place, device will be rusted or shortcut in those area.
Do not rip, bend or squeezed the wiring by heavy object, or it will be hot to fire.
1. Input: 9-36V, LS803 is suitable for both 12V and 24V vehicle, and have good high voltage protection.
2. very lower power consumption, average current less then 100mA in 12V car, and 60mA in 24V car, similar with leakage from the battery, almost does not consume battery power.
3. I/O output, high resistance status under normal status, low voltage output when triggered.
4. Working Temprature: 0-80℃
5. Working Humility: 10%-90%
6. Weigh:108g
7. Demension: 4.5*10.2cm
Product Tags:
|
|
Driving Monitoring Driver Fatigue Warning System 2 Seconds Reflection Time Images
|
